News Center
News Center
What is the cause of deformation of rubber products
Release time:
2024-04-08
Author:
Source:
The water tank gasket manufacturer introduced that at the same time, the synthetic rubber is mixed with each other, which also has the effect of improving performance. If a single IIR is used to make tire inner tubes, although the air tightness is very good, defects such as softening of the carcass, sticking to the outer tube and larger inner tube size will occur after a long time of use. If the rubber product manufacturer mixes IIR with a small amount of EPDM, the above defects can be effectively overcome.
In daily life, there will be some rubber products around. Some people will find some deformation in the process of using them. In fact, this is caused by long-term use. Of course, there are many specific factors. It depends on how to analyze and understand.
rubber products deformation:
1. The manufacturer of the water tank gasket introduces that long-term work does not move and causes permanent deformation. It is used under high pressure for a long time. Under high pressure, it is easy to deform for products with relatively hard materials.
2. The influence of stretching rate is determined by the hardness and softness of the product. Generally, the winning rate of silicone rubber can reach 300 to 600 (relatively soft material). However, excessive stretching during use will directly lead to deformation and loss of stretching degree and permanent deformation. Therefore, it should not be excessively elongated during use, regardless of industrial products, daily necessities or silicone jewelry.
3, the impact of temperature occasions, a humid place, when the silicone rubber products to work, in the case of high temperature in the process of use, stretching will gradually deform, but with the temperature of adaptation and decline will also lead to silicone products appear slight deformation. Therefore, no matter whether it is an industrial application of accessories or sealing products, in addition to human thought, try not to let silicone products stretch for a long time.
The water tank gasket manufacturer introduced that at the same time, the synthetic rubber is mixed with each other, which also has the effect of improving performance. If a single IIR is used to make tire inner tubes, although the air tightness is very good, defects such as softening of the carcass, sticking to the outer tube and larger inner tube size will occur after a long time of use. If the rubber product manufacturer mixes IIR with a small amount of EPDM, the above defects can be effectively overcome.
Key words:
Previous Page
Next Page
Previous Page:
Next page:
recommend News
Contact Us
Address: Jiamaying Township Industrial Park, Wucheng County
Customer Message
